Comet system forum

Discussion forum about Comet system products

Temperature, Humdity,

Pressure Transmitters

and Data Loggers

You are not logged in.

#1 10-09-2008 11:01:20

bitas
Member
Registered: 10-09-2008
Posts: 1

Reset MS5 to factory default

It is possible reset MS5 configuration to factory default(ip address, security etc..) using console cable or by setting jumpers?
Thank you!

Offline

 

#2 11-09-2008 07:30:51

HonzaD
Administrator
Registered: 11-08-2008
Posts: 294

Re: Reset MS5 to factory default

Hi bitas,

If you need clear ethernet configuration use "factory default" jumper - see service manual (request only).

Factory default:
· password to telnet is erased and protection of interface is cancelled
· addresses of e-mail recipients are erased
· rules for e-mail sending (assignment to alarms) are erased
· IP addresses trap recipients are erased
· IP address of syslog server is erased
· IP address of remote server is erased
· telnet is enabled
· udp port 0x77FE is enabled
· upload of interface FW via TFTP protocol is enabled
· www pages are enabled
· acquisition of actual measured values from data logger with interval is enabled
· IP address of transmitter is set to 192.168.1.211


John

Offline

 

#3 27-09-2013 09:31:37

ozgekaya
Member
Registered: 27-09-2013
Posts: 3

Re: Reset MS5 to factory default

Hello John,

I have a problem with ethernet socket of MS6D. Where can I find the  Service Manual for jumper configuration?

Offline

 

#4 27-09-2013 11:09:01

HonzaD
Administrator
Registered: 11-08-2008
Posts: 294

Re: Reset MS5 to factory default

Hi,

Please contact our technical support directly on email info@cometsystem.cz or contact your local distributor.


John

Offline

 

Board footer

Powered by PunBB | CZ / SK
© Copyright 2002–2005 Rickard Andersson