Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
#1 10-09-2008 11:01:20
- bitas
- Member
- Registered: 10-09-2008
- Posts: 1
Reset MS5 to factory default
It is possible reset MS5 configuration to factory default(ip address, security etc..) using console cable or by setting jumpers?
Thank you!
Offline
#2 11-09-2008 07:30:51
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: Reset MS5 to factory default
Hi bitas,
If you need clear ethernet configuration use "factory default" jumper - see service manual (request only).
Factory default:
· password to telnet is erased and protection of interface is cancelled
· addresses of e-mail recipients are erased
· rules for e-mail sending (assignment to alarms) are erased
· IP addresses trap recipients are erased
· IP address of syslog server is erased
· IP address of remote server is erased
· telnet is enabled
· udp port 0x77FE is enabled
· upload of interface FW via TFTP protocol is enabled
· www pages are enabled
· acquisition of actual measured values from data logger with interval is enabled
· IP address of transmitter is set to 192.168.1.211
John
Offline
#3 27-09-2013 09:31:37
- ozgekaya
- Member
- Registered: 27-09-2013
- Posts: 3
Re: Reset MS5 to factory default
Hello John,
I have a problem with ethernet socket of MS6D. Where can I find the Service Manual for jumper configuration?
Offline
#4 27-09-2013 11:09:01
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: Reset MS5 to factory default
Hi,
Please contact our technical support directly on email info@cometsystem.cz or contact your local distributor.
John
Offline