Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
#1 16-08-2013 09:36:05
- Port80
- Member
- Registered: 16-08-2013
- Posts: 3
P8631 stopped working properly after firmware upgrade
Hi,
I have a P8631 sensor, which up until today was running firmware 4.5.1.
To get the new web interface and the new SNMP OIB's I decided to upgrade to 4.5.5.04.
After the upgrade the web interface is degraded, and the device does not respond to the new OID's such as 1.3.6.1.4.1.22626.1.5.1.1.
The web interface does not display any of the setup buttons, and when trying to enter setup1.cfg and m.html manually I get the page as plain text.
I have tried to restore the device to factory defaults, but this did not help. I suspect a failed upgrade, and would like to try to reinstall the current firmware, but was unable to find out how to do this with the current application.
Please help.
Offline
#2 16-08-2013 09:43:39
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: P8631 stopped working properly after firmware upgrade
Hi,
please check your mailbox.
Jan
Offline
#3 16-08-2013 09:47:55
- Port80
- Member
- Registered: 16-08-2013
- Posts: 3
Re: P8631 stopped working properly after firmware upgrade
Thanks, this resolved the issue.
I suspect that this was caused by Trend Micro OfficeScan running and somehow stopping a part of the process.
Offline