Comet system forum

kaveman · 10-12-2008 10:59:30

Hi
I’m trying to connect to P8511 via SNMP and i’m experiencing some problems
I configured the device but IP address, Enabled SNMP and set password “public”
Now when is scan the device (NMap) I get message:

161/udp open|filtered snmp

There is no firewall on the way.
Ping is working for the device but when I try to get any sign that SNMP is working I get this:

$ snmptest 10.10.1.3
snmptest: Timeout

$snmptest -c public 10.10.1.3
snmptest: Timeout

$snmpbulkget -c public 10.10.1.3 .1.3.6.1.4.1.22626.1.5.2.1.3.0
snmpbulkget: Timeout

As I understand the device is using SNMP v1 ??
My firmware version is 4-4-1.04 (I see that newer firmware is available but can’t find any info how to put it on the device?? any help?)

HonzaD · 10-12-2008 12:11:22

Hi,

Yes SNMP v1 is supported. Your P8511 firmware is too old. First step is firmware update. Simple way how upgrade firmware is TSensor software (run with /service parameter and Main menu->Service->Firmware upgrade). TSensor is available only for Windows (maybe you can run TSensor by Wine). Firmware upgrade use TFTP protocol (binary mode). You can also write command:

Code:

tftp -i 10.10.1.3 put 4_5_1_16.rom X5

then download MIBbrowser (http://www.ireasoning.com/), MIB table (http://cometsystem.cz/dnload/MIBtables.zip), check P8511 configuration, and try again...

John

kaveman · 10-12-2008 12:54:06

Thanks
Firmware upgrage helped

Comet system forum

Temperature, Humdity,

Pressure Transmitters

and Data Loggers

#1 10-12-2008 10:59:30

SNMP Problem

#2 10-12-2008 12:11:22

Re: SNMP Problem

Code:

#3 10-12-2008 12:54:06

Re: SNMP Problem

Board footer