Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
#1 30-09-2008 15:00:36
- Tazatel
- Member
- Registered: 30-05-2007
- Posts: 30
TSensor program and RS-485 to Ethernet Converter
I have Comet T-3419 temperature sensor and hygrometer. Can you please send me detail information how to communicate with sensor by creating virtual com port? I used COM PORT Redirector program to redirect virtual com port to IP address of my RS-485 to Ethernet Converter (UDS 1100). But still I couldn’t communicate with the sensor unsing TSensor program.
Offline
#2 30-09-2008 15:06:05
- RadimM
- Administrator
- Registered: 30-05-2007
- Posts: 17
Re: TSensor program and RS-485 to Ethernet Converter
If you visit a www page http://your_converter_IP_address, you will see some others UDS 1100 configuration settings.
Please set correct protocol (RS485 – 2 wire for your sensor).
You also need to set correct Baud Rate and Stop Bits (2 for Modbus, 1 for Advantech Adam).
Press OK button after it and, finally, do Apply Settings.
Offline