Comet system forum

Discussion forum about Comet system products

Temperature, Humdity,

Pressure Transmitters

and Data Loggers

You are not logged in.

#1 19-05-2021 15:14:34

ezapalac
Member
Registered: 19-05-2021
Posts: 2

T3311 and hyperterminal

Sensor out of box works fine with TSensor software however cannot get any response in hyperterminal.
When the connection is established with hyperterminal, the sensor powers up.
When trying to send basic commands, i never get any response.

Using settings:
9600 baud
8 data bits
no parity
2 stop bits
hardware flow control

send:
#010

receive:
nothing

Are there any examples that show basic communication with this sensor via with something like LabVIEW, C#, Visual Basic, etc.?

Offline

 

#2 19-05-2021 22:12:07

ezapalac
Member
Registered: 19-05-2021
Posts: 2

Re: T3311 and hyperterminal

Please dis-regard the previous inquiry. I now have a LabVIEW VI written and communicating successfully with the sensor.

Offline

 

#3 20-05-2021 06:31:09

HonzaD
Administrator
Registered: 11-08-2008
Posts: 294

Re: T3311 and hyperterminal

Hi,

Glad to hear, that you was able resolve your issue.

Regards,

Jan

Offline

 

Board footer

Powered by PunBB | CZ / SK
© Copyright 2002–2005 Rickard Andersson