Comet system forum

Discussion forum about Comet system products

Temperature, Humdity,

Pressure Transmitters

and Data Loggers

You are not logged in.

#1 28-09-2017 22:25:22

innotech
Member
Registered: 28-09-2017
Posts: 2

T3610 SOAP to SQL Server

Hello,

    We recently purchased a Web sensor T3610 for the Power over Ethernet and the SOAP capabilities.  We have the device powered on and it is displaying temperature and humidity.  We are trying to configure the SOAP web service to record data into our SQL database.  We have used the C# code example posted in http://forum.cometsystem.cz/viewtopic.php?id=769.  The service is installed on our IIS service under the internal address http://158.192.75.4/webservices/TempSen … 5xxSample.  We are using the Sensors Setup Utility v. 3.3.0.0 to configure the SOAP settings.  We cannot seem to get the device to talk to our service.  Using the above address, what do we put in the server address and destination port fields for the device to talk to our service.  Also, is there any other method of debugging this other than the diagnostic screen which has the following information?

SOAP
En: 1
St: 8
Last: 500
Cnt (req/ok): 60 690/0
ErrCnt (arp/sock/req/dns): 0/0/60 690/0
File soap.conf: ok
File soap: ok

Thanks

Offline

 

#2 29-09-2017 06:40:04

HonzaD
Administrator
Registered: 11-08-2008
Posts: 294

Re: T3610 SOAP to SQL Server

Hi,

In your case it looks that device sends values properly into your web server. But your server returns http code 500 (=Internal Server Error) instead code 200 (=OK). I am not sure what can be wrong in your case actually. But you should try set target address only to "http://158.192.75.4/webservices/TempSensors/TempSensors.asmx".

Maybe you can use latest version of SOAP SDK. File you can download here - soap-tx5xx-tx6xx.zip.

BTW: What firmware version do you have inside your device?

Jan

Offline

 

#3 29-09-2017 19:41:51

innotech
Member
Registered: 28-09-2017
Posts: 2

Re: T3610 SOAP to SQL Server

Hello,

     Thanks for the quick reply.  We downloaded the latest SOAP SDK and using that code we got the device/web service working.  The firmware version is 1-5-7-3.1236 (Snow leopard).  I have now sent the device to our electronics department to test how it works out on our lab floor.   




Thanks,

Offline

 

Board footer

Powered by PunBB | CZ / SK
© Copyright 2002–2005 Rickard Andersson