Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
#1 10-06-2013 19:20:48
P8541 Both Leds blinking, unable to connect
I can't see the web-interface, can't connect with Telnet, and I have tried all methods of changing IP (DHCP on or off, typing in MAC etc etc)..
Tsensor can FIND it, but I can not connect. I do see it on the network, but all I can do is ping it.
Both Leds over the Ethernet-port are blinking about every 0.5 seconds.
What can I do to make it work again?
Kind regards
Spinner
Offline
#2 11-06-2013 07:07:26
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: P8541 Both Leds blinking, unable to connect
Hi Spinner,
This blink code sounds like a unsuccessful firmware update. But if you see device in TSensor software, there is good chance to restore your device. Please check you mailbox.
Jan
Offline