Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
#1 14-03-2013 18:34:58
- fredrik.edin
- Member
- Registered: 14-03-2013
- Posts: 1
Web server not working after FW update
Hi,
I updated the firmware on my P8510. I can connect to it via the Sensors Setup Utility and see the current temperature but when visiting the web page no values are shown (correct sensor name, channel name but no temperature, history or channel settings).
Tried to reset to factory settings twice. Could there have been some error during update? Is it possible to update again (tried that but get the message that the latest version already is installed)?
Best regards,
Fredrik Edin
Offline
#2 18-03-2013 11:17:26
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: Web server not working after FW update
Hi,
Problem with this device was unsuccessful update. Device has new firmware but web interface was old. After web new upload problem was fixed.
Jan
Offline