Hi

We cant seem to connect with TSensor , but the P8541 was working and showing correct values on the webpage etc...

Anyhow We updated to the newest FW and it was showing a temp of 1283C on only one sensor, would only ever show one sensor (2 plugged in)
Tried factory resets etc, could only ever find one probe and always showed 1283C or -287F or something silly..
We Still couldn't connect with TSensor  (It finds the device but says "Firmware version on the connecting device is not supported by this program version")

Rolled back to the older working firmware and now we cant get any probe information, and still cant connect with TSensor.
So basically we have a useless box...

I've tried the factory defaults serveral times, on both firmwares, and the jumper inside.

currently a telnet session shows the below , we have tried going into probe settings in telnet to find the probes but it doesnt find them..

Any ideas???

********  P8541  Setup Server 4-5-1.21 ********
MAC address 00204AB00ABC

Software version V4.5.1.21 (100316) CPK6500_XPTEX

***** Alarm Configuration *****
Channel 1: Channel 1
  ROM code: 00 00 00 00 00 00 00 00
Channel 2: Channel 2

  ROM code: 00 00 00 00 00 00 00 00