Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
#1 21-12-2012 07:56:52
- gghiri
- Member
- Registered: 21-12-2012
- Posts: 2
P8541 problem with probes
I have upgrade the firmware and now, after "find sensor", i lost the combination probe - channel
I cannot exchange sensor position.
How can i move ROM code from one channel to another?
Offline
#2 07-01-2013 09:54:46
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: P8541 problem with probes
Hi,
I am sorry for a late answer. I was out of office.
Algorithm of finding probes is in new firmware same as at old firmware. Old and new firmware find problems at same sequence. Inside T-Sensor software for old firmware was feature which allows switch probes (ROM codes) between channels. This feature was removed from T-Sensor for new firmware. For this moment there is no way how switch channels with new firmware. Maybe for future we can to add feature back, if this will be requested by many customers.
Jan
Offline
#3 11-02-2013 12:57:58
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: P8541 problem with probes
Hi,
We have ready new web pages (v 1.20), where is possible to change channels order. For more information please contact our technical support directly.
Jan
Offline
#4 13-02-2013 12:18:47
- gghiri
- Member
- Registered: 21-12-2012
- Posts: 2
Re: P8541 problem with probes
Thank you. I immediately communicated with the technical department.
Giorgio
Last edited by gghiri (13-02-2013 12:19:13)
Offline