Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
#1 29-08-2012 21:37:25
- brianmca
- Member
- Registered: 29-08-2012
- Posts: 9
telnet connection refused
I see references to telnet in this forum, and in the manuals. I have a T3511, a H0350 and two H3350s. None of them allow telnet connections and I don't see any settings in TSensor to enable it. The T3511 is brand new and has newer firmware than I can get from this site.
What am I missing ?
Offline
#2 30-08-2012 06:48:40
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: telnet connection refused
Hello,
Use telnet on port 9999 not a standard port 23.
Jan
Offline
#3 30-08-2012 15:38:10
- brianmca
- Member
- Registered: 29-08-2012
- Posts: 9
Re: telnet connection refused
Ok, thanks.
This could be documented more clearly in the manual. I did find it in the section about network connectivity problems, which I hadn't needed to look at. I used to read manuals cover to cover on principle. Somehow that was easier with paper...
Offline