Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
#1 12-06-2012 18:58:52
- actron
- Member
- Registered: 12-06-2012
- Posts: 1
T4411 modbus settings
Hi
I have 2 T4411 and 1 T2414 for monitoring system.
My system works with following settings: modbus, 8 bits, noparity, 1 stop bit
i can't change stop bits in devices mentioned above. Must be 1 stop bit but devices have 2. Is there any way to change it? I realy need it.
BR
Offline
#2 13-06-2012 08:25:01
- PetrS
- Administrator
- Registered: 29-05-2007
- Posts: 34
Re: T4411 modbus settings
Setting change is not possible, but should not be necessary, because of device SENDS two stop bits, but for RECEIVE one stop bit is enough. It should works as is.
Offline