Comet system forum

Discussion forum about Comet system products

Temperature, Humdity,

Pressure Transmitters

and Data Loggers

You are not logged in.

#1 14-03-2013 18:34:58

fredrik.edin
Member
Registered: 14-03-2013
Posts: 1

Web server not working after FW update

Hi,

I updated the firmware on my P8510. I can connect to it via the Sensors Setup Utility and see the current temperature but when visiting the web page no values are shown (correct sensor name, channel name but no temperature, history or channel settings).

Tried to reset to factory settings twice. Could there have been some error during update? Is it possible to update again (tried that but get the message that the latest version already is installed)?

Best regards,
Fredrik Edin

Offline

 

#2 18-03-2013 11:17:26

HonzaD
Administrator
Registered: 11-08-2008
Posts: 293

Re: Web server not working after FW update

Hi,

Problem with this device was unsuccessful update. Device has new firmware but web interface was old. After web new upload problem was fixed.


Jan

Offline

 

Board footer

Powered by PunBB | CZ / SK
© Copyright 2002–2005 Rickard Andersson