Comet system forum

Discussion forum about Comet system products

Temperature, Humdity,

Pressure Transmitters

and Data Loggers

You are not logged in.

#1 07-03-2011 11:04:43

rtheys
Member
Registered: 07-03-2011
Posts: 1

Reading sensor data using SNMP

Hi,

We have the LAN adapter connected to a data logger that logs the information of 4 channels (temperature). I can use SNMP to read the values from the lan adapter MIB, but these only show the trap status. How can I use SNMP to read the actual sensor information?

Here's an snmp walk of the comet snmp tree:

$ snmpwalk -v1 -c public datalogatv enterprises.22626
SNMPv2-SMI::enterprises.22626.1.3.1.1.0 = ""
SNMPv2-SMI::enterprises.22626.1.3.1.2.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.1.3.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.1.4.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.1.5.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.1.6.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.1.7.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.1.8.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.1.9.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.2.1.1.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.2.2.1.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.2.3.1.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.2.4.1.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.2.5.1.0 = INTEGER: 0
SNMPv2-SMI::enterprises.22626.1.3.2.6.1.0 = INTEGER: 0
End of MIB

Regards,

Rik

Offline

 

#2 07-03-2011 12:27:24

MichalV
Administrator
Registered: 18-06-2007
Posts: 132

Re: Reading sensor data using SNMP

Hi Rik,

Unfortunately it can't be possible read measured values from data logger by SNMP using LAN adapter.

Mike

Offline

 

Board footer

Powered by PunBB | CZ / SK
© Copyright 2002–2005 Rickard Andersson