Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
Pages: 1
- Index
- » Ethernet sensors EN
- » T3511 - stop working with Tsensor program after firmware update
#1 10-02-2009 09:47:04
- daveroneb
- Member
- Registered: 10-02-2009
- Posts: 5
T3511 - stop working with Tsensor program after firmware update
T3511 ethernet temp. & humidity unit
1.5.1.06 firmware
v2.3.0.0 Tsensor program
Following update to firmware the Tsensor program will not connect to device
WWW pages working
Device same subnet as pc and has worked Tsensor on prev. version normally
any help appreciated !
thankyou 
Offline
#2 10-02-2009 11:02:57
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: T3511 - stop working with Tsensor program after firmware update
Try factory default via Telnet on port 9999.
Code:
telnet <IP> 9999 (e.g. command telnet 192.168.1.132 9999)
then press 7 .... factory default, 9 .... Seve and exit, and then try connect TSensor
John
Offline
#3 10-02-2009 12:27:00
- daveroneb
- Member
- Registered: 10-02-2009
- Posts: 5
Re: T3511 - stop working with Tsensor program after firmware update
Ok thanks John, worked a treat!
Offline
Pages: 1
- Index
- » Ethernet sensors EN
- » T3511 - stop working with Tsensor program after firmware update