Comet system forum
Discussion forum about Comet system products
Temperature, Humdity,
Pressure Transmitters
and Data Loggers
You are not logged in.
Pages: 1
- Index
- » Software EN
- » Sensors Setup Utility send message: “Firmware version on the connectin
#1 02-02-2018 15:10:06
- danf
- Member
- Registered: 02-02-2018
- Posts: 3
Sensors Setup Utility send message: “Firmware version on the connectin
Hi,
We use Sensors Setup Utility to setup IP configuration and when we click on the “connect button” we got the message “Firmware version on the connecting device is not supported by this program version”. Have you a more recent version? Anyway, we finally configure the sensor using the web page.
Offline
#2 05-02-2018 12:32:20
- HonzaD
- Administrator
- Registered: 11-08-2008
- Posts: 294
Re: Sensors Setup Utility send message: “Firmware version on the connectin
Hi danf,
Did you try use latest version of TSensor software? Latest version of TSensor you can download at TSensor software. Can you provide device type + firmware version and TSensor software version?
Jan
Offline
#3 06-02-2018 08:35:45
- danf
- Member
- Registered: 02-02-2018
- Posts: 3
Re: Sensors Setup Utility send message: “Firmware version on the connectin
Hi,
I previously use TSensor-3.2.6.0, but I just download the TSensor-3.3.2.0, and now it's Ok
Thanks a lot
Offline
Pages: 1
- Index
- » Software EN
- » Sensors Setup Utility send message: “Firmware version on the connectin